Specifications

cape sequence.

Range: 0−255

Default: 43

Units: ASCII

S3 Command Line Termination Character (user defined)

This register determines the ASCII values as the carriage return character. This

character is used to end command lines and result codes.

Range: 0−127, ASCII decimal

Default: 13 (carriage return)

Units: ASCII

S4 Response Formatting Character (user defined)

This register determines the ASCII value used as the line feed character. The

modem uses a line feed character in command mode when it responds to the com-

puter.

Range: 0−127, ASCII decimal

Default: 10 (line feed)

Units: ASCII

S5 Command Line Editing Character (user defined)

This register sets the character recognized as a backspace and pertains to asyn-

chronous only. The modem will not recognize the backspace character if it is set

to a value that is greater than 32 ASCII. This character can be used to edit a

command line. When the echo command is enabled, the modem echoes back to

the local DTE the backspace character, an ASCII space character, and a second

backspace character. This means a total of three characters are transmitted each

time the modem processes the backspace character.

Range: 0−32, 127

Default: 8 (backspace)

Units: ASCII

S6 Wait Before Dialing

This register sets the length of time, in seconds, that the modem must wait (pause)

after going off-hook before dialing the first digit of the telephone number. The

modem always pauses for a minimum of two seconds, even if the value of S6 is