Specifications

32
Result Codes:
OK n = 0, 1
ERROR Otherwise
Wn Result Code Option
W0: CONNECT result code reports DTE speed. Disable protocol result codes.
W1: CONNECT result code reports DTE speed. Enable protocol result codes.
W2: CONNECT result code reports DCE speed. Enable protocol result codes
(default).
Result Codes:
OK n = 0, 1, 2
ERROR Otherwise
Xn Result Code Selection and Call Progress Monitoring
This command enables tone detection options used in the dialing process. As these
functions are chosen, the modem chipsets result codes are also affected. There-
fore, this command is frequently used to control the modem chipsets responses.
The primary function of this control is to control the modem chip sets call re-
sponse capabilities.
Extended Result Codes
Disabled: Displays only the basic result codes OK, CONNECT, RING,
NO CARRIER, and ERROR.
Enabled: Displays basic result codes, along with the connect message
and the modems data rate, and an indication of the modems
error correction and data compression operation.
Dial Tone Detect
Disabled: The modem dials a call regardless of whether it detects a dial
tone. The period of time the modem waits before dialing is speci-
fied in register S6.
Enabled: The modem dials only upon detection of a dial tone, and dis-
connects the call if the dial tone is not detected within 10 sec-
onds.