User manual

66
Actiontec Broadband Router User Manual
67
Chapter 5 Configuring the Router’s Security
• Trusted device - a packet from a trusted device has been accepted.
• Default policy - a packet has been accepted/blocked according to the
default policy.
• Remote administration - a packet designated for the Router management
has been accepted/blocked.
• Access control - a packet has been accepted/blocked because of an access
control rule.
• Parental control - a packet has been blocked because of parental control.
• NAT out failed - NAT failed for this packet.
• DHCP request - the Router sent a DHCP request (depends on the distribu-
tion)
• DHCP response - the Router received a DHCP response (depends on the
distribution)
• DHCP relay agent - a DHCP relay packet has been received (depends on the
distribution)
• IGMP packet - an IGMP packet has been accepted.
• Multicast IGMP connection - a multicast packet has been accepted.
• PPTP connection - a packet inquiring whether the Router is ready to
receive a PPTP connection has been accepted.
• AUTH:113 request - an outbound packet for AUTH protocol has been
accepted (for maximum security level).
• IPV6 over IPV4 - an IPv6 over IPv4 packet has been accepted.
• ARP - an ARP packet has been accepted.
• PPP Discover - a PPP discover packet has been accepted.
• PPP Session - a PPP session packet has been accepted.
• 802.1Q - a 802.1Q (VLAN) packet has been accepted.
• Outbound Auth1X - an outbound Auth1X packet has been accepted.
• IP Version 6 - an IPv6 packet has been accepted.