User guide

37 BT I-Connect User Guide
BT Telecommunications PLC 2003-2005
If a non-WiFi profile is selected, the signal strength bar is disabled and will appear greyed, as
shown above.
See also
Troubleshooting
Frequently Asked Questions
Back up
3.4.1 Nokia D211
For users of Nokia's D211 WiFi card it is recommended that on Windows 2000/XP the Nokia D211
V1.41 Beta drivers are used, contact your IT administrator if you require these drivers. The
previous versions (as supplied on the installation CD) are unable to connect to certain Wireless
Access Points and do not support encryption in
BT I-Connect
.
Under Windows 2000 when the Nokia D211 card is inserted, a dialog similar to that above will be
displayed. To use the card with
BT I-Connect
you must select 'WLAN (infrastructure)' under the
'Easy connection' profile and click
OK
. This places the card into WiFi Mode. They will then be
prompted for an SSID to connect to. A space (' ') is the recommended value for this dialog, but any
of the listed SSID could also be selected.
Note:
BT I-Connect
creates a profile in the Nokia management software called 'BT Client Profile'.
This is expected and the profile should be ignored.