User`s manual

Step 6 Put the chassis cover back on the computer.

Step 7 Be sure all of your system’s components are turned off, then reconnect the

power cables to the computer and its peripherals.

Step 8 Connect the telephone line cable to the Line (Telco) jack as shown below.

Figure 3: Connecting Devices

On the rear panel of your modem are input jacks to connect devices to the

modem. As shown in the diagram, there are jacks for connection to a phone

and to a phone line. The connector labeled “Line (Telco)” is meant to be

connected to a standard analog phone line. To help reduce the load on your

phone line, it is recommended that the modem be the only device con-

nected.

Step 9 Turn on the computer and proceed to the following sections to configure

the your computer’s operating system for use with the 56K Internal PCI

Call Waiting Modem.