User`s manual

Step 10 Windows NT will complete the installation of the modem. Remove the

modem’s installation CD from the CD-ROM drive. Click Finish.

Step 11 If you wish to use the modem to dial a Windows NT Remote Access Server

or wish to connect to the Internet, you will need to configure Dial-Up

Networking. On the Windows taskbar, click Start. On the Start menu,

click Settings, then click Control Panel. In Control Panel, double-click the

Network icon. (If the networking components of Windows NT 4.0 have

not been installed, perform this process before attempting to configure Re-

mote Access Services.) Click the Services folder and select Remote Access

Service.

Note: If the Remote Access Service option is not listed, click the Add button.

Scroll-down the menu and select Remote Access Service. Click the OK

button. Windows NT may ask for it’s own installation CD-ROM for some

files. Insert as required. After you have installed Remote Access Services,

add the appropriate protocols as directed (i.e. TCP/IP for Internet Access).

Step 12 (Continued from Step 11) At the Remote Access Setup dialog box, click

Add. Select the modem as the RAS Device and then click the OK button.

Step 13 Click Continue to finish the installation.

Step 14 After Windows NT has completed the binding process, allow Windows to

shut down and restart the computer.

Step 15 Turn to the section titled “Configuring Your Modem’s Country Code” for

instructions on how to configure the modem to use the Public Switched

Telephone Network (PSTN) of your country.