Instruction manual

Known Limitations in Release 4.1
4-8 296-1011-220 Rel. 4.1, Doc. Rev. 07.02
CVX Multi-Service Access Switch 4.1 Release Notes
6 Enter the configure ip_interface command to access the IP
configuration objects that you need to set for Frame Relay, as follows:
• ip_ifnumber
• ip_circuit
.../FrInterface 1/FrLogicalIF 1> configure
ip_interface
.../FrLogicalIF 1/ip_interface> configure
ip_ifnumber
.../FrLogicalIF 1/ip_interface/ip_ifnumber> set
if_index 1
The if_index
value is the same as the local_if_index value under
ip_route
.
.../FrLogicalIF 1/ip_interface/ip_ifnumber> set
class protocol
.../FrLogicalIF 1/ip_interface/ip_ifnumber> set
subclass fr
.../FrLogicalIF 1/ip_interface/ip_ifnumber> set
instance 1
.../FrLogicalIF 1/ip_interface/ip_ifnumber> commit
.../FrLogicalIF 1/ip_interface/ip_ifnumber> return
.../FrLogicalIF 1/ip_interface> configure ip_circuit
.../FrLogicalIF 1/ip_interface/ip_circuit> set
ip_index 1
.../ip_interface/ip_circuit> set ip_local
134.177.66.21
.../ip_interface/ip_circuit> set ip_mask
255.255.255.0
.../ip_interface/ip_circuit> set inverse_arp_enabled
true
.../ip_interface/ip_circuit> commit
.../ip_interface/ip_circuit> return
.../FrInterface 1/FrLogicalIF 1/ip_interface> return
.../FrInterface 1/FrLogicalIF 1> configure
frlogicalif_config
.../FrLogicalIF 1/frLogicalIF_config> set
frLIFEnable enable
.../FrLogicalIF 1/frLogicalIF_config> commit
.../FrLogicalIF 1/frLogicalIF_config> return
.../VirtualLink 1/FrInterface 1/FrLogicalIF 1>
return
.../VirtualLink 1/FrInterface 1> return
.../T1 1/LeasedLine/VirtualLink 1>
Step Action