Instruction manual

Known Limitations in Release 4.1
296-1011-220 Rel. 4.1, Doc. Rev. 07.02 4-7
Known Problems and Limitations
5 At the FRInterface 1 level of the CLI hierarchy, enter the configure
frlogicalif command.
The number that you enter following the configure frlogicalif
command is the Frame Relay logical interface number. The number
that you enter following the configure frcircuit_config command is
the number that indicates the DLCI to be used on this interface. You
should use unique DLCI values for the entire Frame Relay interface.
.../VirtualLink 1/FrInterface 1> configure
frlogicalif 1
.../FrInterface 1/FrLogicalIF 1> configure
frcircuit_config 16
.../FrInterface 1/FrLogicalIF 1/FrCircuit_config 16>
return
.../FrInterface 1/FrLogicalIF 1>
Step Action