Instruction manual

Known Limitations in Release 4.1
4-6 296-1011-220 Rel. 4.1, Doc. Rev. 07.02
CVX Multi-Service Access Switch 4.1 Release Notes
Step Action
1 Go to the T1 level of the CLI hierarchy.
CVX> config
Entering Configuration Mode
CONFIG> configure shelf 1/slot 9/scc/bic/t1 1
2 Enter the configure leasedline and configure virtuallink commands.
The number that you enter following the configure virtuallink
command is the T1 port number. Only one virtual link is allowed for
each T1.
shelf 1/slot 9/SCC/BIC/T1 1> configure leasedline
.../BIC/T1 1/LeasedLine> configure virtuallink 1
.../BIC/T1 1/LeasedLine/VirtualLink 1>
3 Enter the configure frinterface command, followed by a number.
The number following the configure frinterface command is the virtual
link port number. Only one FrInterface per virtual link is allowed.
.../T1 1/LeasedLine/VirtualLink 1> configure
frinterface 1
4 Enter the configure frinterface_config command to access and set
the Frame Relay configuration parameters.
The set frDlcmiLMIType command used in this step specifies the data
link connection management identifier (DLCMI) scheme on the Frame
Relay interface. Your carrier can tell you which DLCMI type to specify.
.../VirtualLink 1/FrInterface 1> configure
frinterface_config
.../FrInterface_config> set frDlcmiLMIType annexd
.../FrInterface_config> commit
.../FrInterface_config> return
.../T1/LeasedLine/VirtualLink 1/FrInterface 1>