Instruction manual

Table of Known Problems
4-2 296-1011-220 Rel. 4.1, Doc. Rev. 07.02
CVX Multi-Service Access Switch 4.1 Release Notes
Table of Known Problems
CR Number Description
5335 Permanent virtual circuits are listed as active instead of active-wait when they are
disconnected from the far end router. Also, the ARP table has only the first entry correct
for the Frame Relay information.
139208-1 OSPF routes are not summarized when an OSPF Range is configured.
139248-1 When using local authentication in VPOP 0/ppp_modem_config, if you set
AuthServerProtocol1 to CHAP and AuthServerProtocol2 to PAP, AuthServerProtocol2
never goes down to PAP and the connection fails. To work around this, set
AuthServerProtocol1 to PAP and AuthServerProtocol2 to CHAP.
139252-1
139253-1
Attempts to configure and walk the following Aptis-Monitoring MIBs have been
unsuccessful:
pppDeadLogEntryTable
pppDeadSessionStatsTable
dvsStatusDeadTable
L2FLinkStatusTable
L2FLogEntryTable
139257-1 The SNMP Get Bulk action returns results for 100 instances regardless of the table
being queried.
139259-1 The session components command and an SNMP walk of
sessioncomponentsIndex display different counts. The counts for both should be the
same.
139260-1 A MIB walk of sessionTraceTable in the Aptis-monitoring MIB displays information for
the first session only.
139274-1 Session Detail Timestamps Do Not Contain Clock Time
The following session attributes show a value representing the number of seconds
relative to system start time, instead of showing actual clock time (date and time):
startTime
stopTime
timeOfModemSync
time OfService
147737-1 The show modems command fails to find modems with an IOP of 3 and a DMM of 6.
For example, show modems 13/3/6/2/3 does not display performance information
about slot 13/IOP 3/DMM 6/pack 2/modem 3.
149443-1 When CPM is configured for monitor mode and the primary CPM server is not available,
the FEP will crash during pre-authentication of a dial up client.