Instruction manual

296-1011-220 Rel. 4.1, Doc. Rev. 07.02 3-5
Corrected Problems
MAC Corrected Problems
This table contains a brief description of each Change Request (CR) completed
for this CVX switch release that affects the MAC.
137570-1 FEP Active and inactive DVS sessions are now recognized correctly in
DVS-specific CLI commands. Previously, with multilink bundles, all sessions
were shown under the dvs active CLI command as inactive when any of the
slave links were terminated.
137568-2 FEP Multilink connections no longer fail after more than two links with bogus
VPOP.
136765-2 FEP The show modem command correctly identifies available commands.
136763-2 FEP The show ethernet stats all command now only provides results for
existing Ethernet ports. In prior releases, non-existent Ethernet ports were
reported as "undiscovered…"
136726-2
139209-1
140416-1
FEP The show route command now displays a complete routing table. Prior to
this release, some routes were occasionally missed.
136313-2 FEP Event filtering now works correctly when a filter is defined for a card in slot
11 through 18. The culprit was a mismatch caused by the difference in the
way the card numbers were determined in the filter record and the card
source.
CR Number Category Release Note
Q00046842 MAC The MAC no longer crashes when closing ClearTCP calls due to improper
calling of tcp_close function or memory block header block corruption.
Q00046251 MAC The CVX MAC will no longer go into a state causing Ethernet frame
discards while handling error conditions.
148799-1 MAC The MAC no longer crashes due to a corrupt queue pointer caused by a
race condition. The resources associated with a session are now freed
when the session is cleared.
148616-1 MAC The MAC no longer crashes due to race conditions caused by ClearTCP
sessions running over the X.75 interface. Instead of clearing the resources
in three steps, all resource associations are now cleared at the same time,
preventing the race condition.
CR Number Category Release Note (continued)