Instruction manual

296-1011-220 Rel. 4.1, Doc. Rev. 07.02 3-3
Corrected Problems
145417-2 FEP The FEP no longer crashes in the Ethernet driver code. The problem
occurred when two processes tried to access a structure at the same time,
causing memory corruption.
145307-3 FEP The FEP no longer crashes during FTP due to a problem with the TCP idle
timer. The socket level timeout was reduced to one minute.
144944-1 FEP The CVX no longer displays the "No Server" message on the FEP console
when there is no accounting server.
144884-2 FEP The FEP no longer crashes due to excessive memory being consumed by
L2F-related events. The number of events per L2F tunnel has been reduced
to 256.
144882-2 FEP The CVX now takes into account variable length subnet masking while
making updates to the routing table.
144866-1 FEP The FEP no longer crashes due to memory corruption caused by an
increase in banner length.
144862-1 FEP The FEP no longer crashes when printing large amounts of data collected in
an rsh RADIUS query. A short delay has been added while printing data.
144646-2 FEP VPOP Strategy Organization Name will now work with the OutputStyle set
to name and the VPOP_config parameter address_mode set to local. New
parameters have been added for this release.
144521-2 FEP The show access-list command now properly displays the access-lists in a
sorted order.
144468-2 FEP During configuration, the CVX now reports an error if an alphanumeric
character is entered when an integer is expected.
144355-2 FEP The CVX switch no longer allows the configuration of vrouters with an id
greater than 32. Prior to this release, the vrouters could be configured with
an ID greater than 32, but were ignored.
144272-3 FEP The CVX switch no longer reports 100% CPU utilization caused by one CLI
task. Associated socket and shell sessions are now properly cleaned up.
144095-2 FEP The FEP no longer crashes under high OSPF loads. The problem occurred
when two processes tried to access a global data structure at the same
time. Conditions have been added to correctly restore a process state.
144064-2 FEP During a telnet session, the vinfo -h command now properly displays its
output. The output was originally directed to the FEP console and appeared
to be lost.
143753-2 FEP The show t1 slot x ds1 y rfc command now displays the correct value for
the CircuitID field.
CR Number Category Release Note (continued)