Instruction manual

3-2 296-1011-220 Rel. 4.1, Doc. Rev. 07.02
CVX Multi-Service Access Switch 4.1 Release Notes
149219-1 FEP The FEP no longer crashes when more than three DNS servers are
configured. Previously, there was no limit enforced by configuration, which
caused memory corruption. Now, the number of DNS servers has been
limited to three. If more than three DNS server are configured, error
messages are written to the event logs while the system is rebooting. Valid
container IDs are 0, 1, and 2.
148309-1 FEP The core dump utility now copies the full 64MB of memory when doing a
core dump on the SCC-II. Prior to this release, the core dump utility
occasionally dumped only 32MB.
147538-1 FEP A Telnet hang caused by the NMAP port scan utility has been corrected.
147447-1 FEP The FEP no longer crashes when the input and output queues do not
release allocated memory.
147209-1 FEP The CVX now sends Ascend Multilink attributes (Ascend-Multilink-ID and
Ascend-Num-In-Multilink) in an accounting stop request only if multilink is
enabled.
146871-1 FEP The Ethernet will no longer show sluggishness due to DNS. The problem
was caused by the invalid use of UDP ports.
146478-1 FEP The Ascend dictionary file is now imported into the aptis.dct file.
146196-2 FEP The FEP no longer crashes with the message "DMM: unable to allocate
memory." The queue size for syslog messages has been limited, and
DTRACE calls have been removed from the syslog function.
146172-1 FEP The FEP no longer hangs when receiving unknown types of MobileIP
packets, which caused it to run out of size0 pbufs. This problem was caused
by a denial of service attack.
146162-2 FEP A Telnet hang caused by race conditions when running the NMAP port scan
utility repeatedly has been corrected.
146062-1 FEP The FEP no longer crashes when issuing the command radius -v 89 -c 30.
The use of this command caused the FEP to reference an uninitialized
RADIUS tracing structure.
146041-1 FEP The FEP no longer hangs during a Telnet session while a CLI task is waiting
for user input. A 30-minute timer has been added to clear the wait state.
145581-1 FEP The SCC-I is now compatible with the 64MB 96-modem CSM6 MAC card
(NTDY40KA). Prior to this release, the FEP reported "Invalid link ID" after
taking 128 calls.
145426-1 FEP The FEP no longer crashes due to the disabling of an Ethernet port which
allowed associated pointers to persist.
CR Number Category Release Note (continued)