Instruction manual

Configuration Changes Since Release 4.0
296-1011-220 Rel. 4.1, Doc. Rev. 07.02 2-19
New Functionality
Creating IP Pool Without Route Aggregation
The following is an example of an IP pool configuration where the CVX switch
does not use route aggregation, as shown in the output of the show routes
command.
Example - Using the Start/Count Method
.../VPOP 1/ip_pool 1/ip_address_block 1> show
Members currently configured at this level:
start 10.10.10.7
count 4
mask 0.0.0.0
range_in_use false
admin_status enabled
CVX> show routes
Routing table display
IP Routes:
D = default, P = private, I = internal, E = external
D 0.0.0.0/0 cid 1 gw 192.168.1.2 igp static/low 1
10.10.10.7/32 cid 100 igp static/high 1
10.10.10.8/32 cid 100 igp static/high 1
10.10.10.9/32 cid 100 igp static/high 1
10.10.10.10/32 cid 100 igp static/high 1
P 192.168.1.0/24 cid 1 igp local cfg 1