Instruction manual

Upgrading to the Double-Density Hardware
1-24 296-1011-220 Rel. 4.1, Doc. Rev. 07.02
CVX Multi-Service Access Switch 4.1 Release Notes
Upgrading to the Double-Density Hardware
Before upgrading to the new double-density DAC, MAC, and SCC-II hardware,
ensure that the CVX switch is operating correctly before performing the upgrade.
Any service problems need to be resolved before performing the upgrade.
The recommended slot locations for both 12xDS1 and 24xDS1 DAC cards are
slots 2, 7, 12, 17.
If you are using CVXView and CPM, refer to Release 4.1 Product
Compatibility (page 1-2) for upgrade compatiblities. If you do not perform
upgrades to CVXView and to CPM, CVXView will not be able to monitor the
CVX switch and CPM may not be able to communicate properly with the CVX
switch.