Instruction manual

Upgrading to Release 4.1 from Prior Releases
296-1011-220 Rel. 4.1, Doc. Rev. 07.02 1-17
Upgrading to Release 4.1
Unsuccessful Boot Results
When the CVX switch completes extracting files and moving them to the C:\
drive, the CVX switch starts the boot process. If the boot.ini file is missing in
flash memory after the default drive is mounted, the CVX switch displays the
following messages:
CVX> cold (step 5 of “Performing a Local Upgrade” starting on page 1-13)
.
.
(files are extracted)
.
...please wait for the system wide initialization
.
.
(waiting for default drive to mount)
.
Drive mounted ...
Starting the TDM Test control task (the boot.ini file cannot be found)
Bootstrap shell starting ...
.
.
.
Slot n (DAC) pcc is ready ...
Slot n (DAC) dmm ready ...
Received ALIVE message from slot <#>
Press the [Return] key. The user name: prompt is displayed.
To restore the boot.ini file to flash memory, perform the following steps:
Step Action
1 At the CVX> prompt, log on only as root (both user name and
password).
CVX>
user name: root
password: root
2 Enter the enable command or the set level 2 command to gain access
to all CVX switch commands.
CVX> set level 2