User`s manual

Table of Contents

0530-0277-000

I. Introduction 2

II. Contacting Actiontec Technical Support 3

III. Before You Begin 4

Product Features 4

Package Contents 5

IV. Installing the Modem 6

V. Installing the Modem Drivers 8

Configuring Windows 98, Windows 2000, Windows ME 8

Configuring Windows NT 4.0 9

Configuring Windows XP 10

VI. Installing Communications Software 12

Installing onWindows 98, NT, 2000, ME 12

Installing on Windows XP 16

VII. The Modem On Hold Feature 21

Installing the Modem On Hold Feature 21

Using the Modem On Hold Feature 24

VIII.Troubleshooting 26

AT Commands 27

IX. Notices 31

X. Safety Information 34

XI. Warranty 35

Proprietary Notice and Disclaimer

Unless otherwise noted, this document and the information herein disclosed are proprietary to Actiontec

Electronics, Inc the manufacturer. Any person or entity to whom this document is furnished or who other-

wise has possession thereof, by acceptance agrees that it will not be copied or reproduced in whole or in

part, nor used in any manner except to meet the purposes for which it was delivered.

The information in this document is subject to change without notice and should not be construed as a com-

mitment by Actiontec the manufacturer. Although Actiontec the manufacturer will make every effort to inform

users of substantive errors, Actiontec the manufacturer disclaims all liability for any loss or damage result-

ing from the use of this document or any hardware or software described herein, including without limitation

contingent, special or incidental liability.

Note: PC is a trademark of IBM Corporation. Windows 95, 98, ME, NT, 2000, XP are a trademarks of

Microsoft Inc. All other brand or product names and logos used in this manual are trademarks or registered

trademarks of their respective holders.

Table of Contents

Page