User manual

20
Actiontec 54 Mbps Wireless PC Card User Manual
21
Chapter 3 Using the Wireless Configuration Utility
2. Type the appropriate WEP key in the text box.
3. Select an authentication type from the “Authentication” list box (Open
System, Shared Key, or Auto Switch).
4. In the “Key Format” section, select the key’s character type (64-bit, 128-bit, or
256-bit).
5. Select the key to use by clicking in the appropriate circle (1, 2, 3, or 4). This
encryption key matches the key used in the device being connected to, such as
an access point or wireless gateway/router.
6. Click OK.
802.1x Configuration
If WEP or WPA is selected in the Privacy Mode list box, and 802.1x is selected in
the Authentication Mode list box, the “802.1x Configuration” window appears.
Protocol - Select an authentication protocol from this section.
Password - if “EAP-TLS” was not selected in the Protocol section, the “Password”
section is active. Enter a login name and password in the appropriate text boxes, or
request that the driver prompt for them when connecting to a wireless network.