User manual

12
Actiontec 11Mbps Wireless Access Point User Manual
☞
Note:Do not use the Ethernet cable included with the Access
Point to connect to a computer. This Ethernet cable is a cross-
over type, and is used to connect the Access Point to a network
hub or switch.
Placing or Mounting the Access Point
The Access Point can be placed on a flat surface (such as a desktop). Ensure there
are no obstructions around the Access Point that may interfere with the sending
and receiving of wireless signals.
The Access Point can also be mounted on a wall. On the bottom panel of the Access
Point are four screw mounting holes. Insert two screws into the wall, and ensure the
screw heads protrude slightly from the wall surface. Mount the access point on the wall.
☞
Note:Ifplanning to mount the Access Point in a hard-to-reach
location, ensure the cables are connected and the Access Point is
configured properly before mounting.
Next, go to “Setting Up the Access Point” on page 13.
LAN
Reset
USB
Power
To Hub,
Switch, or
Computer
To Power
Outlet