User manual

FiOS Router User Manual
57
© 2010 Verizon. All Rights Reserved.
Click 2. Add in the “Networked computer/Device” column. The “Add Access
Control Rule” screen appears.
If this access control rule applies to all networked devices, select “Any” from 3.
the “Networked Computer/Device” list box. If this rule applies to certain
devices only, select “User Defined” and click Add. Then, in the “Edit Network
Object” screen, add a network object (for more details about adding
network objects, see the “Advanced Settings” chapter of this manual).
Select the Internet protocol to be blocked from the “Protocol” drop- 4.
down list.
If this rule will be active continuously, select 5. Always from the “When should
this rule occur?” drop-down list. If the rule will only be active at certain times,
select “User Defined” and click Add. Then, add a schedule rule (for more
details about schedule rules, see the “Advanced Settings” chapter of
this manual).
Note: Make sure the FiOS Router’s date and time settings for your time zone are
set correctly for schedule rules to function properly.
Click 6. Apply to save the changes. The Access Control screen will display a
summary of the access control rule.
Note: To block a service that is not included in the list, select “User Defined”
from the Protocol drop-down menu. The “Edit Service” screen appears. Define
the service, then click Apply. The service will then be automatically added to the
top section of the “Add Access Control Rule” screen, and will be selectable.
The user may disable an access control and the service made available without
having to remove the service from the Access Control table. This may be useful
to make the service available only temporarily, with the expectation that the
restriction will be reinstated later.
To temporarily disable an access control, clear the check box next to the t
network computer/device.