User's Manual

Appendix A - Remote Controllers34
Repeat these steps for each Z-Wave device in your home until you have successfully added all your modules.
(Make sure to assign a different channel number for each device, otherwise you could end up turning on more
than one device together)
10.3 Programming the zControl to Use the Remote Controller
Open your zControl Interface. ›
Turn on Administrator Mode and then click on the Settings icon in the bottom-right corner ›
Click on the Z-Wave icon ›
Now using the remote, press and Hold the › INCLUDE button for 5 seconds. Both Red and Green LEDs will
flash. Release the INCLUDE button.
Press and release › Channel 2 ON/DIM on the remote. The Green LED will flash to indicate “Transmit All infor-
mation”.
Press the › LEARN button on the Z-Wave Admin page on the zControl Interface
Your zControl should now be able to control your new devices.
If the Learn fails, please repeat these steps again as the remote controller may have timed out the “Transmit All
Information”.
NOTE: Each time you add/remove new Z-Wave devices to the remote control, you must complete this step to
Learn the new devices on the zControl).