User's Manual

WxB6x40Q Wireless Network Extender

e Extender is now synced with the gateway/modem’s Wi-Fi settings.

Unplug the Extender and its power cable.

Connecting the Extender

Now that the Extender is synced with the gateway/modem’s wireless

network, it can be connected to the gateway/modem’s MoCA or Ethernet

network .To do this:

1. For Coax: Connect the included coaxial cable into the Coax port on

the rear panel of the Extender. Connect the other end of the coaxial

cable into the nearby coaxial outlet. (25 /lbs torque max)

2. For Ethernet: Connect the included ethernet cable into a Yellow port

on the rear panel of the Extender. Connect the other end of the

ethernet cable into an ethernet port on the back of the Wi-Fi Router.

3. Plug the Extender’s power adapter into the Power port of the

Extender, and the other end into an electrical wall outlet.

4. If applicable, connect an Ethernet cable between one of the Extender’s

LAN ports and the Ethernet port of a non-wireless device (wireless

devices will connect via the wireless network).

5. Wait until the Wireless LEDs on the front panel of the Extender glow

green. is may take a few minutes.

e Extender is now synced, installed, and extending the gateway/

modem’s wireless network in a previously weak area.