User's Manual
Installing the Extender
6.
Wait until the Coax and Wireless LEDs on the front panel of the
Extender glow green. is may take a few minutes.
The Extender is now synced, installed, and extending the gateway/modem’s
wireless network in a previously weak area. Using the wireless network will
be a seamless experience, as the wireless devices will switch between
connecting to the Extender and the gateway/router automatically.
Using a Coaxial Splitter
If another device is using the coaxial outlet needed from step 3 in the
previous procedure, perform the following steps:
1.
Disconnect the coaxial cable from the coaxial outlet.
2.
Connect a coaxial cable between the coaxial outlet and the single port
on a two-way coaxial splitter.
3.
Connect the coaxial cable disconnected in step 1of this procedure to
one of the dual ports on the splitter.
4.
Connect a coaxial cable between the Coax port of the Extender and
the other dual port on the splitter.
e nal conguration should be similar to the inset in the gure on the
previous page.
9