Actiontec Electronics, Inc. 760 North Mary Ave., Sunnyvale, CA 94085 USA Gateway Device with Z‐Wave Home Control and optional WiFi Model #: SG250 Quick Start Guide Version: 0.
Connect the SG250 Gateway to Power and Router 1. Plug one end of the Ethernet cable to the Ethernet port on the SG250 gateway. 2. Plug the other end of the Ethernet cable into the LAN port on the back of your router. 3. Plug the AC power adapter connector to the SG250 gateway’s power port. (Power: External, 12V DC, 1A made by Leader Electronics Inc.; Model: MT12‐Y120100‐A1) 4. Now plug the power adapter into a properly grounded power outlet. 5. Make sure the power LED light on the Gateway device is green.
Specifications 1. Features • Marvell 800 MHz CPU, ARMv5 architecture • 256 MB NAND SLC flash memory • 256 MB DDR3 RAM memory • Compliant with IEEE 802.3 Ethernet standard, supports 100BaseT. • 2.4 GHz IEEE 802.11n compliant • 2‐stream spatial multiplexing up to 135 Mbps • Supports 20 MHz channels • Full IEEE 802.
General Regulatory and Compliance Notices Important Safety Instructions If applicable, when using telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electrical shock, and personal injury, including the following: Do not use this product near water – for example, near a bathtub, kitchen sink, laundry tub, or swimming pool, or in a wet basement; Avoid using a telephone (other than a cordless type) during an electrical storm, as there may be a remote risk of ele
Avis d’application de la réglementation et de conformité généraux Consignes de sécurité importantes Afin de réduire les risques d’incendie, de blessures corporelles ou d’électrocution, suivez toujours ces mesures préventives de base lorsque vous utilisez votre téléphone. N’utilisez pas ce produit près de l’eau, par exemple, à proximité d’une baignoire, d’un évier de cuisine, d’une cuve à lessive, d’une piscine ou dans un sous-sol humide.
