User's Manual

2. Click the Yes button next to “Reset Settings to Factory”.

3. Click OK on the pop-up message box to confirm.

4. The receiver reboots, and the receiver is reset to factory defaults after the reboot.

Note: You can also reset your receiver to default by pressing the "Reset" button. Follow the

procedure below to restore the Receiver's default factory settings:

1. Power on the Receiver, and wait until the "Ready to connect" screen appears.

2. Hold down the Receiver's "Reset" button with a pin.

3. When the "Reset to Default" screen appears on the HDTV, release the "Reset" button.

The Receiver reboots, and it will be running with its default settings.

5.4. Upgrading the Receiver

ScreenBeam Pro supports firmware upgrade. And Actiontec’s ScreenBeam team will

constantly improve the receiver’s performance with new firmware.

Follow the procedure below to upgrade your receiver:

1. Log into ScreenBeam Pro’s web server, and go to the Features tab page by clicking the

Features tab.

2. Set the USB Local Access feature to Only allow firmware update, or Enable.