User's Manual

• Increase the separation between the equipment and receiver;
• Connect the equipment to an outlet on a circuit dierent from that to which the receiver is connected;
• Consult the dealer or an experience radio or television technician for help.
Modications
The FCC requires the user to be notied that any changes or modications made to this device that
are not expressly approved by Actiontec Electronics, Inc, may void the user’s authority to operate the
equipment.
Declaration of conformity for products marked with the FCC logo – United States only.
This device complies with Part 15 of the FCC Rules and with Industry Canada license-exempt RSS stan-
dard(s). Operation is subject to the following two conditions:
General Regulatory and Compliance Notices
Important Safety Instructions
If applicable, when using electronic equipment, basic safety precautions should always be followed to
reduce the risk of re, electrical shock, and personal injury, including the following:
• Do not use this product near water – for example, near a bathtub, kitchen sink, laundry tub, or swim-
ming pool, or in a wet basement.
FCC Class B Equipment
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmfulinterference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment o and on, the user is encouraged to try and correct the
interference by implementing one or more of the following measures:
• Reorient or relocate the receiving antenna;