Manualshelf

User's Manual

ManualsBrandsActiontec Electronics ManualsElectronicsMyWirelessTV3 Wireless HD Transmitter, 4K Wireless HD Connection Kit
12345678910
7
Draft
2. Plug oneend of the HDMI cable into an HDMI port on the HDTV monitor.
3. Plug the other end of the HDMI cable into the HDMI OuttoTV port on the Receiver.
4. Plug the connector of the power cord into the 5VDC / 2Aport on the Receiver.And plug
the AC adapterof the power supply into a power outlet.
5. Verify that the POWER LED on the Receiver is SOLID green.
6. Wait for a bit as the Receiver connects to the Transmitter. The LINK LED should show
SOLID Green once they're connected.
7. Turn on the TV and switch the source to the HDMI input that the Receiver is connected
to.You should see content beingstreamed from the source device.
2.4. Setting up IR Control
The IR Blaster Cable connects to your Wireless HD VideoTransmitter. The IR Blaster can
receive IR signal from your source device’s remote control over MyWirelessTV network,
andemits the IR signal to control the source device. Thus, you cancontrol the source device
from wherever the TV and Wireless HDVideo Receiver are located.
The IR Receiver Extension Cable extends the IR receiver of theWireless HD Video Receiver.
Thus, it allows the Receiver toreceive IR signal from the remote control, if the device is
placed inan area where IR signal is not in line-of-sight of the source’sremote control. Use of
this cable is optional.
Note: If the Receiver and Transmitter are in the same room,setting up IR Blaster cable is not
required.
2.4.1. Connecting the IR Blaster Cable
The IR Blaster cable receives the source device remote control signal fromthe Receiver and
delivers it to the source device.
1. Get the IR Blaster cable from theMyWirelessTV kit box. The IR Blaster cable has a
black connector.
2. Plug the black connector of the IR Blaster cable into the IR Transmitport on the
Transmitter.
3. Locate the Infrared (IR) sensor on your source device box.
4. The IR Blaster head comes with a hook-and-loop fastener. Detach the loop strip from
the fastener, and peel off the release liner of the adhesive tape. Stick the loop strip near
the Infrared (IR) sensor on your source device.
5. Mount the IR Blaster head by attaching the hook and loop strips together.
2.4.2. Connecting the IR Receiver Extension Cable
The IR Receiver ExtensionCable receives signals from the source device remotecontrol and
sends them back to the source device.
1. Get the IR Receiver ExtensionCable from theMyWirelessTV kit. The IR Receiver
ExtensionCable has a green connector.