User Manual

Installing the Extender

ere are two parts to installing an Extender: syncing the Wi-Fi settings,

and placing and connecting the Extender.

Syncing Wi-Fi

To sync the Extender with the gateway/modem’s Wi-Fi settings:

1. Place the Extender next to the gateway/modem.

2. Plug the Extender’s power adapter into the Power port of the

Extender, and the other end into an electrical wall outlet.

3. Press the WPS button on both the Extender and the gateway/modem

simultaneously for ten seconds.

4. Make sure the WPS button on the Extender is glowing green. If the

WPS button glows red, try syncing the Wi-Fi settings again. e

Extender can also be manually congured to connect with the

gateway/modem’s wireless network (see “Wireless Setup” on !

page 14).

e Extender is now synced with the gateway/modem’s Wi-Fi settings.

Unplug the Extender and its power cable and continue on to the next

section of this chapter, “Connecting the Extender.”"