Actiontec Electronics, Inc. 760 North Mary Ave., Sunnyvale, CA 94085 USA Wireless 11ac Ethernet Gateway Model #: F2300 Quick Start Guide Version: 2.
Connect the Gateway to a Computer 1. Get F2300 from the Quick Start Kit and take it out of the bag. 2. Get the Power Cord from your DSL Quick Start Kit. (Power Adapter External 12VDC, 2A; Model: STD-12020U1 by Actiontec) 3. Plug the smaller end of the Power Cord into the Black Port on the back of the Gateway. 4. Plug the larger end of the Power Cord into a Power Outlet. 5. Make sure the Power Switch is On. 6. Make sure the Power Light on the Gateway is SOLID Green. 7. Get the Yellow Cable 8.
Specifications 1. Features • Supports Plug-and-Play installation. • Compliant with IEEE 802.3 Ethernet standard. • Supports 10BaseT and 100BaseT and Gigabit. • 2.4 GHz IEEE 802.11n • 5GHz IEEE 802.11ac/11n • Supports 20 MHz channels with optional SGI • Full IEEE 802.11 b/g/n legacy compatibility with enhanced performance Comprehensive wireless network security support that includes WPA, WPA2, and AES encryption/decryption coupled with TKIP and IEEE 802.1X support • Support 802.
FCC_GR&CN_pkginsrt_Canada10_FCC Reg_Comp sheet_10x6 2/7/13 10:08 AM Page 1 General Regulatory and Compliance Notices Important Safety Instructions Modifications If applicable, when using telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electrical shock, and personal injury, including the following: Do not use this product near water – for example, near a bathtub, kitchen sink, laundry tub, or swimming pool, or in a wet basement; Avoid using a telephone (
