Bluetooth BTM200 OEM Installation Manual
Contents 1. 2. 3. 4. 5. 6.
2. Introduction Thank you for purchasing Actiontec USB Bluetooth Wireless Module. This manual will assist you with the installation procedure. The package you have received should contain the following items: • USB Bluetooth Wireless Module • OEM Installation Manual • Wireless LAN Management utility and driver software. Note: if anything is missing, please contact your vendor The diskette contains drivers and utility software; this is used for managing the Bluetooth and needed components.
3. Wireless Bluetooth Basics Wireless Bluetooth systems offer a great number of advantages over a traditional, wired system. Wireless Bluetooth are more flexible, easier to setup and manage and often more cost effective than their wired equivalence. Using radio frequency (RF) technology. Bluetooth transmits and receives data over the air, minimizing the need for wired connections. Thus, Bluetooth combines data connectivity with user mobility, and, through simplified configuration, enable movable LANs.
4. OEM Installation Procedures of Bluetooth Please follow the below steps one by one to install the utility and driver software successfully. 1. Take JST connector to plug into the 8-pin connector located on the same side of the PCB as antenna. 2. Power on your PC and allow Windows to load fully. 3. Windows first time detects the USB device (Bluetooth by HP); click “cancel”. 4. Insert the given Installation diskette and then double click the setup.exe file to run setup. 5.
5. Troubleshooting USB Bluetooth Wireless Module If you still encounter some problems while installing the Bluetooth utility and driver software or you want to confirm whether your software is installed properly or not, we have listed the procedure for checking the various components after you have installed the software. In section below, we have listed the various problems that you may encounter during the installation and have also listed the possible solution.
6. Technical Specification of Bluetooth Hardware compatibility • IBM-compatible computers Driver support • Windows 95 • Windows 98 • Windows NT4.0 • Windows 2000 • Windows Me Standards supported • Bluetooth spec. 1.1 • USB version 1.1 Environmental Operating temperature: • 0 degree Celsius to 70 degree Celsius (Operating) –20 to 85 (storing) • Max. Humidity 95 % Non-condensing Power specifications Operating voltage: • +5 V, +3.3V DC +- 5 % Radio specifications Range: • per cell indoors approx.
Mobility: • Seamless roaming across cell boundaries with handover Data encryption: • 40 bit WEP Encryption, 128-bit key length Utility software: • Link Config User setup & diagnostics tool Physical Dimensions • 26 x 14 x 5.7mm IO Connector • Hose Interface Connector: • Regulation • • • • Bluetooth RF Connector: FCC FCC Canada Europe • Japan • Other 40 Pin Hirose DF12-40DS-0.5V(89) connector to the host SMT Ultra Miniature coax RF connector, Hirose U.FL-R-SMT Part 15 Class B CFR 47 Part 15.
Regulatory Compliance Notices Class B Equipment This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
