User's Manual

7
Regulatory Compliance
Notices Class B Equipment
This equipment has been tested and
found to comply with the limits for a
Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are
designed to provide reasonable
protection against harmful interference
in a residential installation. This
equipment generates, uses, and can
radiate radio frequency energy and, if
not installed and used in accordance with
the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or
television reception, which can be
determined by turning the equipment off
and on, the user is encouraged to try to
correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced
radio or television technician for help.
Modifications
The FCC requires the user to be notified
that any changes or modifications made
to this device that are not expressly
approved by Actiontec Electronics, Inc
may void the user’s authority to operate
the equipment.
Declaration of conformity for products
marked with the FCC logo – United
States only
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This
device may not cause harmful
interference, and
(2) This device must accept any
interference received, including
interference that may cause undesired
operation.
"IMPORTANT NOTE: To comply
with FCC RF exposure
compliance requirements the
antenna used for this
transmitter must be
installed to provide a
separation distance of at
least 20 cm from all
persons and must not be co-
located or operating in
conjunction with any other
antenna or transmitter."
For questions regarding your product, or
the FCC declaration, contact:
Actiontec Electronics, Inc
760 North Mary Ave,
Sunnyvale, CA 94086
United States
Tel: [phone]
Fax: [phone]