User's Manual
Table Of Contents
- Page 1
- Page 2
- Page 3
- Page 4
- Page 5
- Page 6
- Page 7
- Page 8
- Page 9
- Page 10
- Page 11
- Page 12
- Page 13
- Page 14
- Page 15
- Page 16
- Page 17
- Page 18
- Page 19
- Page 20
- Page 21
- Page 22
- Page 23
- Page 24
- Page 25
- Page 26
- Page 27
- Page 28
- Page 29
- Page 30
- Page 31
- Page 32
- Page 33
- Page 34
- Page 35
- Page 36
- Page 37
- Page 38
- Page 39
- Page 40
- Page 41
- Page 42
- Page 43
- Page 44
- Page 45
- Page 46
- Page 47
- Page 48
FLO TV Introduction
Please refer to the following as an overview to use the FLO TV service:
1. Turn the vehicle ignition key to the ON position. Turn on your VOH10FR and select the FLO TV source by pressing the Source button
on the overhead or by pressing the FLOTV Button on the remote. (Note: Watching the FLO TV service for an extended period of time
with the engine OFF will run down the vehicle's battery.)
2. The VOH10FR screen will show the FLO TV splash screen which will appear for about 30 seconds and then the FLO TV preview
channel or the last channel that was being viewed.
3. Press the p (up arrow) or q (down arrow) key on the remote to change channels.
4. Press the (Guide) key on the remote to access the FLO TV Channel Guide.
5. The arrow keys (pqt u) on the remote allow for navigation through the Channel Guide.
6. Press the ENTER key on the remote to select a desired channel/show from the Channel Guide.
7. Press the (Information) key on the remote to display the program information related to the current program.
8. Press the (Settings) key on the remote to access the FLO TV user settings menu (e.g. Parental Control, etc.).
9. The Mode key on the remote allows the user to switch between the FLO TV service and an auxiliary A/V source if one is connected.
10. Visit www.flotv.com for more info.
24