User`s manual

/ actiNAS Manager · Network
86
Network Adaptor Configuration Options
Device
Shows the network device name. eth0 is the device name for LAN0 gigabit port.
IP
Shows the current IP address of the network device. Configure the IP address as necessary.
Gateway
Show the current IP address of the Gateway. To edit, enter the Gateway IP address
Subnet Mask
Shows the current subnet mask setting. To edit, type in the new subnet mask number.
MTU
The MTU size (Maximum Transmission Unit) in bytes. To modify the MTU size for this
interface, select the new MTU size. Options are: 1500 (default), 2000, 3000, 4000, 5000,
6000
MAC address
Shows the MAC address of network device.
Enable on Boot
If enabled, this adapter will be active when actiNAS starts up
Dynamic IP
(BOOTP/DHCP)
If checked, this specifies that this network device will dynamically obtain an IP address from
a Dynamic Host Configuration Protocol (DHCP) server or from a Bootstrap Protocol
(BOOTP) server
Default Gateway
If checked, the default gateway will be enabled in this adapter. A default gateway is a local IP
router that is used to forward packets to destination beyond the local network. Only one
default gateway in the NAS can be enabled in a certain time.
Reset
Use this button to undo or clear any changes made.
Apply
Use this button to save the changes made.
Create Trunking
Use this button to configure network trunking.