User`s manual

www.acti.com
Encoder Firmware V4.09.22 User’s Manual
66
better overall accuracy in both day and night conditions. Some night time only MD regions may
also be activated this way. The event period will end when the camera returns to day mode,
which will then reset the camera to the original settings.
Ready for service: This will trigger the event responses once the device boots up. You can use
this to create a notification system that keeps record of when the device has been rebooted via
email.
Service is not available: This triggers the event response when the device is shut down via
web UI “Save and Reboot”. Use this to keep record of when was the device setting edited. Note
that this will not take effect when the device is unplugged, as this is not normal shutdown.
What responses will occur?
Digital Output (selected models only): This is an useful link to other devices. Click to include
this in the response for this rule.
Send notification Message: Select from the three pre-defined messages which you‟ve setup
in the Event Configuration section. You may enable multiple messages at the same time. For
sending Email, please limit the recipient to one per event rule. If you need to send email to
more than one recipient, please use separate event rules triggered by the same trigger.
Upload video/snapshots: Select which of the event configurations to include in this response
set. If you are sending email via upload video and sending notification message at the same
time, the system will automatically merge the two emails into one. The subject and image will
be based upon the Upload snapshot Event configuration enabled, but the message in the body
text will be based upon the Notification messages.
In general, please stick to the “one email per event rule” limit for best performance.
Change Motion Detection profile: This will switch the profile of the selected Motion Detection