User`s manual

www.acti.com
Encoder Firmware V4.09.22 User’s Manual
6
3. Open Internet Explorer , and type in Default IP:
http://192.168.0.100
4. When you see the login window, please input default user and password:
Default Username: Admin Password: 123456
5. After you log in, you will see the video from IP device. To go to the main menu, click the
“Setup” button on the top left.
6. Please go to IP settings -> Connection Type. Change the IP mode to Static and the IP
address to 192.168.0.101 or any other unused IP (Avoid 192.168.0.100, the IPs of your
PCs and other devices already in network.). Click “Apply” then click System -> Save &
Reboot.
7. Internet Explorer will close after a few seconds. This is normal.
8. Wait for 30 seconds and open IE again by typing in the new IP. (In this example,
192.168.0.101). For later device you add into the network, please choose an IP that does
not is not used by any existing device.
9. If you have more than one device, continue again from step 2. Assign different new IP to
each camera (for instance -> 192.168.0.102, 192.168.0.103 …). You do not need to unplug
the existing devices from the switch because there is no IP conflict.