User`s manual

www.acti.com

Encoder Firmware V4.09.22 User’s Manual

Manual: Manually select the Exposure Gain and

Shutter Speed below..

White Balance

(In

Indoor/Outdoor/Auto/Hold

profiles only)

Select the white balance mode. After you set the

parameter, you need to wait for 5~10seconds to see the

final result.

1. AUTO : Auto white balance (default)

2. INDOOR1: Select the indoor white balance

profile 1.

3. INDOOR2: Select the indoor white balance

profile 2.

4. OUTDOOR1: Select the outdoor white balance

profile 1.

5. OUTDOOR2: Select the outdoor white balance

profile 2

6. HOLD: Select this to let the IP camera

automatically obtain a best white balance

setting according to current environment. The

IP camera will use this setting to adjust color.

NOTE: This setting will be lost after you

reboot the camera.

For all the settings above, you will need to setup

the value for AE Reference Target and

Maximum auto shutter speed.

7. MANUAL: Select this to enable manual setting

of the white balance. You will need to enter the

R Gain and B Gain setting below.

AE Reference Target

This is the desired image brightness output level. The

camera will attempt to change the exposure levels or

digital amplification levels to achieve this level of

brightness. Increasing this may provide a brighter

image, but if there are extremely dark areas, this may

also create slightly more noise in the underexposed

areas.

Maximum auto shutter

speed

The maximum allowed time for the camera to take a

single image.

Click the [Apply] button to confirm the settings or click the [Reset] button to re-enter

the parameters.