User`s manual

www.acti.com
Encoder Firmware V4.09.22 User’s Manual
37
Day/Night (CMOS Non-D/N Models)
This tab concerns the day and night switch timing for your camera. Please refer to the table
below.
Parameters
Description
Switch from Day
mode to Night mode
This value controls the level of light where camera switches into
night mode. Increasing it will make camera switch to night mode
at a darker illumination level.
Switch if lasts more
than X seconds
The camera will only switch day/night status if the illumination
level stays either above or below the boundary for this much
time. This is to prevent a temporary brightness change from
triggering unnecessary day/night changes.
Brightness Meter Bar
This bar shows the illumination level at which cameras go to
night or day mode (Blue bars), and shows the current detected