User`s manual

www.acti.com
Encoder Firmware V4.09.22 User’s Manual
30
IP Settings
Connection Type
Click the [Connection Type] item to display the “Connection Type Page”. Refer to the table
below for how to configure each setting.
Parameters
Description
Dynamic IP
address
Click this to enable IP device‟s DHCP function.
It will acquire its WAN port IP address from a DHCP server within the
same network. (You must have a DHCP server in order to enable this
function.)
Static IP
address
Click this to manually enter the IP address.
IP address: Enter the WAN port IP address.
Subnet mask: Enter the subnet mask of WAN port. If IP address
is changed, adjust the subnet mask accordingly.
ISP gateway: Enter the IP address of the gateway (the router).
PPPoE
Click this when you connect IP device directly to the xDSL modem.
User name: Enter the user name of your xDSL account.
Password: Enter the password of your xDSL account.
Note: You have to click the [Save Reboot] after you click the [Apply
button] to let this IP device start xDSL connections.