User`s manual

www.acti.com
Encoder Firmware V4.09.22 User’s Manual
17
Date & Time
Click the [Date & Time] item under Setup to see Date Setting Page. Refer to the table below for
how to configure each setting. The default method is to set manually.
Date Setting
Parameters
Description
SNTP/NTP
server
Click this to enable IP device‟s SNTP/NTP function. This enables this IP
device to synchronize its time settings with a SNTP/NTP server. You can
use this function to make sure all your IP devices‟ time is the same.
Additionally, with our embedded digital-time-code in the streaming, you
can tell the event sequence accurately.
IP address: Enter the IP address of the SNTP/NTP server.
Sync time: Select the time interval for this IP device to synchronize
its time.