Manual

www.acti.com
Firmware User’s Manual V6.09.45
73
Parameters
Description
3DNR.
Edge Enhancement
(for I-series only)
Select the Edge Enhancement value. The higher the value, the
sharper the image.
Defogging
(for I-series only)
This feature provides a clear image even when the camera is installed
in a foggy environment. Select the Defogging level: Disabled, Low,
Medium, High, and Highest. Wherein “Low” is ideal for a slightly foggy
environment and “Highest” for the foggiest environment.
NOTE: After upgrading the camera firmware to V.6.08.30, make sure
to update the ISP file which is included in the firmware package file.
For more information, refer to the Release Note downloadable from
the website.
Image Stabilization
(for I-series PTZ /
Speed Domes only)
This feature has no obvious effect under normal viewing conditions.
However, if the camera is installed inside a moving vehicle, such as a
train, etc., enable this feature to make the image stable even when
the environment is in constant motion.
After changing any of the items above, press Apply to save the changes. The Reset button
undoes the changes that had just been made but not Applied yet.
The button “Restore image settings to default” is a quick way of restoring factory default
image settings without needing to reset the whole camera to factory default.