Manual

www.acti.com
Firmware User’s Manual V6.09.45
103
Change Motion Detection profile: This will switch the profile of the selected Motion Detection
region from Runtime profile to Event profile. The profile will return to runtime settings at the end of
this event. You may program one motion detection region to be disabled at runtime, but enable it
with event handler under some circumstances.
Send URL command: Select the URL command to include in the response set. Two different
commands will be sent at the time when the event is triggered and un-triggered. For example,
going to a preset point, if the device is a PTZ camera, and there are preset points already
configured in PTZ setup page, then you may include this in the response section of the event rule
by using Send URL Command method. It is possible to let the camera return to another preset
point at the end of the event.
Change to Day / Night Mode (Selected models only): For some models, you may force the
Camera into Day or Night mode. The camera will return to its previous setting (whether auto or
forced day/ night) upon the end of the event.
After changing any of the items above, press Apply to save the changes. The Reset button
undoes the changes that had just been made but not Applied yet.