Specifications

www.acti.com
ENR-1000 Series System Administrator’s Manual
46
Network Settings
There are two network interface cards in ENR. Either of these cards can be supported by the
built-in DHCP server feature, which enables ENR to assign IP addresses to cameras via
LAN1 or LAN2 port without another DHCP on router.
Go to Setup page  Network tab
The current settings of both LANs will be displayed here.
By default, LAN1 card is set to Manual mode with a fixed IP address 192.168.0.10, while
LAN2 is in DHCP client mode. It is suggested that you connect LAN1 to LAN and connect
LAN2 to WAN.