Installation guide

www.acti.com
ENR-1000 System Administrator’s Manual
47
1. Once a device is added to ENR server, the server would provide empty rules with
compatible trigger types for you to configure such as Motion 1, Motion 2, Motion 3,
DI 1, DI 2, Network Loss and Network Recovery. Select the Event Type, then click
“Set”.
2. Select the trigger type:
Trigger DO
Setup the DO to become ON or OFF upon trigger, only the devices supporting DO
functions are available. Check the “Enable” to enable this function, and the device whose
connected DO(s) will be triggered. You may select one DO to be activated after the other
if both DOs are well-set and the duration time between them. Clik “OK” to confirm.
Send Mail
Enable ENR to send email notifications via SMTP service.Check the “Enable” to enable
this function, and fill in the mail recipient’s email address in “To” field, notification title in