Installation guide

www.acti.com
ENR-1000 System Administrator’s Manual
36
Network Settings
You may check the network adapter setting of LAN1 and LAN2 via the path: Live View Menu
 Select “Setup Menu”  click “System Settings” tab  click “Network”.
Configure LAN1 Settings
As LAN1 port supports only DHCP server function. Without the DHCP client capability, it
cannot get IP from another DHCP server, and you will have to define its IP Address and
Subnet Mask manually if necessary. The default IP is 192.168.0.10.
Turn On/Off the DHCP Server
By default, the DHCP server is enabled. It will assign IP addresses to the cameras which are
in DHCP (client) mode. You may also define the range of IP address ENR assigns to the
cameras.
Simply enable the DHCP Server by checking the box “Enable DHCP Server”, fill in the
beginning IP address in Start IP Address field, and the ending IP Address in End IP
Address field. The default range is 192.168.0.101~192.168.0.200.