Technical data

Diagnosis
Operating Manual
79ID 442281.00
WE KEEP THINGS MOVING
13
13.3.12 42:TempBrakeRes
13.3.13 44:External fault
Resolution Level Response Fault counter
The i
2
t model for the braking resistor ex-
ceeds 100% load.
Malfunc-
tion
The parameterized malfunction reaction in the
A29 parameter. Note that this event often results
in the triggering of Event 36: Overvoltage. In this
case, the motor coasts.
Z42
Possible cause Test Measure Acknowledgement
The braking resistor
may not be designed
according to the appli-
cation.
Check whether the load state of the
braking resistor has caused over-
heating.
Check the drive configuration. Con-
sider a DC link connection or the use
of a braking resistor with a larger
power rating.
Programmed acknowledgement; ac-
knowledgement by switching of/on is
not recommended as in this case the
i
2
t model is reset to 80 %. As a result,
there is a risk that the braking resistor
will be damaged.
Resolution Level Response Fault counter
Application-specific or by free program-
ming option
Malfunction The parameterized malfunction reaction in the A29 parameter. Z44
Possible cause Test Measure Acknowledgement
Application-specific or
due to free program-
ming option; can be
separately programmed
for each axis
— — Switch the device on/off or
programmed acknowledge-
ment