Technical data

Service

ID 442281.00

WE KEEP THINGS MOVING

Operating Manual

12 Service

This chapter lists various service jobs and explains their performance.

12.1 Replacing inverters

This chapter provides you with an introduction to the simple replacement of two

inverters without additional aids. Only the Paramodule from the replaced inverter

must be used on the new inverter. In the Paramodule, the action A00 save values

stores the programming and the parameterization of the inverter safe from a pow-

er failure.

The following conditions apply to the replacement:

• The new inverter takes over the job of the replaced inverter. There are no

changes in the drive task.

• Inverters of the same device type are exchanged.

• The new inverter has the same hardware and software status as the inverter

to be replaced or a higher one.

• None of the devices or components (motor, shaft encoder, option board, and

so on) to be configured on the inverter change.

Proceed as shown below:

Information

If inverters of different types are replaced or the devices to be config-

ured on the inverter are changed, the entire configuration must be

changed with POSITool and checked!

Replacing the inverter

1 Start the action A00 save values. Wait until the action has been concluded

with the result 0:error free.

2 Turn the power supply of the inverter off. Wait until the indication on the dis-

play disappears.

3 Unplug Paramodule from the inverter to be replaced!

Inverter to be replaced