Technical data

Parameterizing brake data

Operating Manual

ID 442281.00

WE KEEP THINGS MOVING

The current motor torque is stored in the setting F08 = 1:active while the brake is

activated. This torque is built up again after the brake is released. If F08 is set to

2:Do not save torque, only the motor flux is built up while the brake is being re-

leased.

When F08 is set to 0:inactive, the brake is activated with system enable A900.In

this case, brake release and application times are ignored.

Use motors with brakes from STÖBER ANTRIEBSTECHNIK GmbH & Co. KG.

Look up the correct values for F07 and F06 in the catalogs. If you use a servo mo-

tor with EnDat

encoder, F07 and F06 will be automatically read from the elec-

tronic nameplate each time the device is started.

If you have connected two brakes to an SDS 5000, enter the greater value in F06

and F07. Also set in B07= 1:arbitrary setting, so that the electronic name plate

does not automatically overwrite these parameters.

To accommodate for the physical factors of motor and brakes, parameterize the

parameter F08 > 0. Please note that the assistant page Holding brake is displayed

dynamically as a function of the control mode selected.

7In F06, enter the time that the brake takes to be released (control modes B20

= 2:vector control and 64:servo-control).

8 Transfer the parameters to the inverter and save them there.

9 Turn the inverter off and on again.

Ö You have parameterized brake activation.