Technical data

4
Parameterize
ID 442281.00
WE KEEP THINGS MOVING
Operating Manual
28
The parameter menu of the inverter is divided into menu groups. The menu
groups are arranged in alphabetical order, beginning with the group A.. Inverter,
B.. Motor, C.. Machine, and so on. Each menu group contains a list of parameters
which are identified by the letter of the group and a consecutive number such as
A00, A01, A02, etc. To change a parameter, proceed as shown below. Use the
Enter key to go from the operation indicators to the menu level.
Fig. 4-4: Menu structure
The menu groups are selected with the arrow keys and activated with .
Use the keys to select the desired parameter within the menu group. You
can switch back and forth between the elements in an array parameter with the
keys. A parameter is then activated for change with . The value flashes
to indicate that it can be changed with . The keys can be used to
select which decade (ones, tens, hundreds, and so on) is to be adjusted. The val-
ue is then accepted with the key or reset with the key. Use the key to
access a higher menu level. To save safe from power failure, all changes must be
stored with the A00 save values = 1:active!
#
3000 rpm 1.3A
4: Enabled
B..
Motor
A..
Inverter
C..
Machine
B26 Motor encoder
3: X140
B26 Motor encoder
3: X140
Accept change
Reject change
Value
flashing
B20 Control mode
0: V/f control
....
Betriebs-
anzeige
Parameter
groups
Parameter
selection
Parameter
entry
#
#
#
ESC
ESC