Quick Installation Guide

~ 2 ~
V. Accessing Your Camera- Manual IP Setup (Without Router/DHCP server)
1. Connect the PC to the Network Switch with the RJ-45 cable, and change your PC’s IP to
192.168.0.99 / Subnet Mask 255.255.255.0
2. Connect the device to your Network Switch. If it is a PoE enabled Switch, then the device is
powered on. If it is NOT a PoE enabled Switch, please also plug in the Power Adapter.
3. Open Internet Explorer (Version 6.0 or above) at http://192.168.0.100
4. When you see the login window, input default username and password:
Default Username: Admin Password: 123456
5. To go to the main menu, click the “Setup” button on the top left after you’ve logged in.
6. For ACM/ACD models, click on “WAN settings”. Change the IP mode to Static and the IP
address to 192.168.0.101 or any other unused IP (Avoid 192.168.0.100, the IPs of your PCs
and other devices already in network.). Click “Apply”, then click “Save and Reboot”.
7. For TCM/TCD/KCM/D/E/B/I models, please go to IP Settings -> Connection Type. Change to
Static IP Address and use 192.168.0.101 or any other unused IP (Avoid 192.168.0.100, the
IPs of your PCs and other devices already in network.). Click “Apply” then click System ->
Save & Reboot.
8. Internet Explorer will close after a few seconds. This is normal.
9. Wait for 30 seconds and test the new IP with Internet Explorer.
10. If you have more than one device, continue again from step 2. Assign different new IP to
each camera (for instance -> 192.168.0.102, 192.168.0.103 …).
If you assign the same IP to two cameras, they will be in IP conflict and will not function normally.
For more details, please follow our User’s Manual.
Online Customer Help Desk: www.acti.com/CHD
ACTi Knowledge Base Articles: www.acti.com/KB