Quick Installation Guide

~ 1 ~

I. Package Contents:

．Camera or Video Encoder ．Power Adapter (only for Video Encoders and Speed Domes)

．Accessories ．Warranty Card

．Quick Installation Guide

II. Required equipments before installation

．PC + Monitor ．RJ-45 Network cable (1 for each device + 1 for PC)

．Network Switch ．Power Adapter with Terminal Block (Optional)

(PoE switches that are IEEE802.3af compliant can power cameras directly without adapter.

For devices connected to non-PoE switches,

please use Power Adapter with terminal block.

Connect the white striped wire to 12V pin, and

the black wire to the GND pin. (See image)

III. Default Settings

．IP Address : 192.168.0.100 ．Username: Admin ．Password: 123456

IV. Accessing Your Camera – Automatic IP Setup (With Router/DHCP server)

1. Connect both the PC and the device to your Network Switch with RJ-45 Network cables. If

this switch supports PoE, the device is already powered on. If it does NOT, please connect

power adaptor to your IP device.

2. You can find your devices either via IP Utility or via Windows Explorer.

IP Utility

Windows Explorer via UPnP

IP Utility is available on our website

http://www.acti.com/IP_Utility

Run IP Utility to start auto device search. Click

on the underlined IP links to access device.

There’s no need to change device IPs.

Go to Start->My Computer and select

“Network” to search. Double-Click on the

device to open its web page. (See image below)

Your default browser must be Internet

Explorer to use this method

PAGE 1
Quick Installation Guide I. Package Contents: ．Camera or Video Encoder ．Power Adapter (only for Video Encoders and Speed Domes) ．Accessories ．Warranty Card ．Quick Installation Guide II. Required equipments before installation ．PC + Monitor ．RJ-45 Network cable (1 for each device + 1 for PC) ．Network Switch ．Power Adapter with Terminal Block (Optional) (PoE switches that are IEEE802.3af compliant can power cameras directly without adapter.
PAGE 2
V. Accessing Your Camera- Manual IP Setup (Without Router/DHCP server) 1. Connect the PC to the Network Switch with the RJ-45 cable, and change your PC’s IP to 192.168.0.99 / Subnet Mask 255.255.255.0 2. Connect the device to your Network Switch. If it is a PoE enabled Switch, then the device is powered on. If it is NOT a PoE enabled Switch, please also plug in the Power Adapter. 3. Open Internet Explorer (Version 6.0 or above) at http://192.168.0.100 4.